User's Manual

RSSI Measurement and Maximum Data Rate Configuration
SU A/E Subscriber Units Installation Manual 20 BreezeACCESS MMDS Series
6.2 Configuring The Maximum Data Rate
5. Use the following table to determine the recommended Maximum Data Rate.
Table 3: RSSI vs. Maximum Data Rate
RSSI Maximum Data Rate
Higher than 97 3 Mbps
From 86 to 97 2Mbps
Lower than 86* 1 Mbps
* If the RSSI is lower than 80 units the link quality is too
low and should be improved through installing the antenna
in a different and/or a higher location.
2. If the measured average RSSI is less than 97 units, the default Maximum
Data Rate of 3 Mbps is to high and should be decreased.
3. From the Basic Configuration menu select 5 to access the Maximum Data
Rate selection menu.
4. Configure the Maximum Data Rate according to Table 3 above.
5. Reset the unit for the new configuration to become effective.