User's Manual

RSSI Measurement and Maximum Data Rate Configuration

BreezeACCESS MMDS Series 19 SU A/E Subscriber Units Installation Manual

6. RSSI MEASUREMENT AND MAXIMUM DATA

RATE CONFIGURATION

6.1 Performing the RSSI Measurement

The Average RSSI Continuous Display test allows a continuously updated

display of the average Received Signal Strength Indication. As the test measures

only the desired signal of properly received frames, it is a good indication to the

quality of the received signal.

Note: As the RSSI bar indicator is not accurate, it is recommended always to

perform the Average RSSI Continuous Display test after the antenna was

optimally aligned.

1. Start the Monitor program as described in Section 3.1.

2. From the

Main Menu

Type 4 to access the

Site

Survey

3. Type 4 to activate the Average RSSI Continuos Display selection screen.

4. On the screen you will get a continuously updated display of RSSI

measurements. To stop the test, press the Esc key.