User's Manual

Configuring System Parameters
BS Equipment Installation Manual 18 BreezeACCESS MMDS Series
1. From the main menu, type 3 to access the Basic Configuration menu.
BreezeACCESS/BST-AU
Official Release Version – 2.5.3
Release Date: Tue Jul 18 21:12:54 2000
Basic Configuration
====================
1 – IP Address
2 – Subnet Mask
3 – Default Gateway Address
4 – ESSID
5 – Maximum Data Rate
6 – Frequency Offset
H – Hopping Band
F – Flexible sub-bands Definition
X - Transmit Power Control
S - Show Basic Configuration
BreezeACCESS >>>
Figure 3-2. Basic Configuration Menu
2. From the Basic Configuration menu, type 1 to access the IP Address
selection screen. Enter the required IP address.
3. Type 2 to access the Subnet Mask selection screen. Enter the required subnet
mask.
4. Type 3 to access the Default Gateway Address selection screen. Enter the
required default gateway address.
5. Type 4 to access the ESSID selection screen. Enter the required ESSID.
6. Type H to access the Hopping Band menu. Enter the required hopping band.
7. If Flexible Hopping was selected in the Hopping Band selection menu, type
F to access the Flexible sub-bands Definition menu. Use the Add/Delete sub-
bands screens to define the required frequencies. See Appendix B for a list of
standard frequencies.
8. Type 6 to access the Frequency Offset selection screen. Enter the required
frequency offset.
9. If more than one AU is used, they should be synchronized for optimal
spectrum utilization. Type 7 to access the Hopping Shift selection screen and