User's Manual

Basic Installation

BreezeACCESS MMDS Series 15 BS Equipment Installation Manual

2.7 Installing the AU-NI Indoor Unit

1. Place the AU-NI unit in an appropriate location on a shelf or a table. The unit

can be wall mounted using the installation materials provided with the unit.

Use a 6mm (1/4”) drill and the supplied template plate for easy and accurate

marking of the holes.

2. Connect the AU -PS power cord to the DC In jack (marked DC-12V) located

on the rear panel of the Indoor unit (shown in Figure 2-6).

3. Connect the IF cable to the IF connector (marked IF) on the rear panel of the

Indoor unit. The other side of the IF cable should already be connected to the

Outdoor unit.

4. Connect the other end of the mains power cord to the AU -PS. Connect the

mains power plug to a mains power outlet.

DC - 12V

ETH

Figure 2-7. AU -NI Rear Panel

5. Verify that the Power LED (marked PWR) located on the front panel of the

Indoor Unit is turned ON.

PWR

WLNK

MON

Figure 2-8. AU -NI Front Panel