User's Manual

Basic Installation
BreezeACCESS MMDS Series 9 BS Equipment Installation Manual
2.5.2 Connecting the Antenna Cable (AU-RE)
Connect an RF cable between the ANT connector (located on the bottom panel of
the unit, shown in Figure 4-1) and the antenna.
2.5.3 Connecting the Ground and IF Cables
The Ground terminal (marked
)
and the IF cable connector (marked IF) are
located on the bottom panel of the Outdoor unit, shown in Figure 4-1.
1. Connect one end of the grounding cable to the Ground terminal and connect
the other end to a good ground connection.
2. Connect the coaxial cable to the IF connector. Verify that the length of the IF
cable is sufficient and that it can easily reach the Indoor unit.
Note: Make sure to switch OFF the power of the indoor unit prior to
connecting/disconnecting the IF cable.