User's Manual
Table Of Contents
- System Description
- Introducing BreezeACCESS 900
- Cell Extender
- Subscriber Unit
- BreezeCONFIG( ACCESS
- Specifications
- Installing the Cell Extender
- Installing the SU-I Subscriber Unit
- Set-up and Initialization
- Aligning the Cell Extender’s SU-RA Antenna
- Aligning the SU-I Subscriber Unit’s Antenna
- Verifying Proper Operation
- Flexible Hopping Definition Mode
Verifying Proper Operation
Table 3-6: SU-RA LEDs
Name Description Functionality
ETH Ethernet
activity
indication
Off –No traffic activity detected on the Ethernet
port
Blinking–Data received from or transmitted to
the Ethernet port
WLNK Wireless Link
Activity Indictor
Blinking– Packets received from the wireless
link
Off – No reception of packets from the wireless
link
ALARM Alarm
Indication
On – A problem with the power amplifier or in
the locking process of any of the synthesizers
Off – Normal operation
Verifying the Ethernet Connection (SU-I)
Once you have connected the unit to a PC, verify that the Ethernet
Integrity indicator (the yellow LED embedded in the Ethernet connector)
is on, indicating that the unit is connected to an Ethernet segment. The
Ethernet Activity indicator (the green embedded LED) should blink
whenever the unit receives or transmits traffic on the Ethernet port.
Verifying Data Connectivity (SU-I)
To verify data connectivity, from the end-user’s PC or from a portable
PC connected to the unit, ping the primary Access Unit, or try to
connect to the Internet.
Manual Revision 1.0 - Preliminary
A
-13