User's Manual
Table Of Contents
- System Description
- Introducing BreezeACCESS 900
- Cell Extender
- Subscriber Unit
- BreezeCONFIG( ACCESS
- Specifications
- Installing the Cell Extender
- Installing the SU-I Subscriber Unit
- Set-up and Initialization
- Aligning the Cell Extender’s SU-RA Antenna
- Aligning the SU-I Subscriber Unit’s Antenna
- Verifying Proper Operation
- Flexible Hopping Definition Mode
Appendix A - Wiring 10Base-T Jacks
Table 3-4: Basic Parameters in the SU-I
Parameter Default Value Comment
IP Address 10.0.0.1
Subnet Mask 255.0.0.0
Default Gateway Address 0.0.0.0
DHCP Options Disable
Access to DHCP From Wlan Only
ESSID ESSID1
Flexible Hopping Definition According to the
spectrum analysis survey
Transmit Antenna Antenna 2 Must remain Antenna 2
Transmit Level 23 dBm
ATPC Option Enable
Best AU Support Disable
Preferred AU MAC Address 00-00-00-00-00-00 (none)
Applicable only when
Best AU Support is
enabled
Scanning Mode Active
VLAN Link Type Hybrid
VLAN ID-Management 65535
Authentication Algorithm Open System Can be changed to
Shared Key only after
configuring the WEP Key
and the applicable
Default Key ID.
Default Key ID 1
WEP Key 1-4 0000000000 (none)
NOTE
Once the basic parameters are configured, the unit must be reset in order to
activate the new configuration.
BreezeACCESSS 900 System Manual
A
-8