User's Manual
Table Of Contents
- System Description
- Introducing BreezeACCESS 900
- Cell Extender
- Subscriber Unit
- BreezeCONFIG( ACCESS
- Specifications
- Installing the Cell Extender
- Installing the SU-I Subscriber Unit
- Set-up and Initialization
- Aligning the Cell Extender’s SU-RA Antenna
- Aligning the SU-I Subscriber Unit’s Antenna
- Verifying Proper Operation
- Flexible Hopping Definition Mode
Set-up and Initialization
Configuring Basic Parameters
The Basic Configuration menu includes all the parameters necessary for
the initial installation and operation of the Cell Extender and the SU-I
units. In many installations, most of these parameters should not be
changed from their default values. The basic parameters and their
default values are listed in Tables 3-2 to 3-4. Once the basic parameters
are configured, the unit must be reset in order to activate the new
configuration.
The functionality of most parameters of BreezeACCESS 900 equipment
is the same as for BreezeACCESS II units. Refer to BreezeACCESS II
System Manual for detailed information on the applicable parameters.
The functionality of the several parameters in BreezeACCESS 900 is
different than in BreezeACCESS II. These parameters are:
Hopping Set and Hopping Sequence parameters are not available.
The Hopping Standard in all BreezeACCESS 900 units is set to
Flexible Hopping Definition. Refer to
Appendix D
for details on how
to configure the required hopping frequencies using the Flexible
Hopping Definition menu.
Antenna Diversity is not supported. The Transmit Antenna
parameter must always be configured to Antenna 2.
Transmit power level is controlled by the Transmit Power parameter.
The range is 3-23dBm in 1dB steps, and the default is 23dBm.
Manual Revision 1.0 - Preliminary
A
-5