User's Manual

Installing the SU-I Subscriber Unit
Installing the Antenna and Lightning Protection
To install the antenna and lightning protection:
1. The antenna can be mounted on a 1”-4” pole. The mounting on a
1”-2.5” pole differs from mounting on a 2.5”-4” pole. You may use
the Wall/Roof Mount Arm available from Alvarion (P/N 872442).
Refer to
Appendix B for instructions on installing the antenna.
NOTE
Vertical polarization: The POLARIZATION arrow should point upward or downward.
Horizontal polarization: The POLARIZATION arrow should be parallel to ground.
2. Install the DC grounding block or optional lighning arrestor near the
point where the antenna cable enters the building and perform all
the required RF and grounding connections according to the
instructions provided in
Appendix C
.
NOTE
All RF cables connections must be adequately sealed against water.
Connecting the Antenna to the Unit
To connect the antenna to the unit:
1. Connect the cable to the connector marked 2 on the side of the unit.
NOTE
Do not remove the runner cover of the connector marked 1, and do not attempt to
connect the antenna to this connector.
2. Use the torque key included in the package to tighten the cable to
the connector. The key is designed to prevent over tightening of the
screws and protects the connectors from damage. If excessive
pressure is applied to tighten the screws, the torque key will break.
NOTE
The use of improper tools for tightening antenna connection cables to BreezeACCESS
units may result in damage to the cable connectors.
Manual Revision 1.0 - Preliminary
2-19