User's Manual
Table Of Contents
- System Description
- Introducing BreezeACCESS 900
- Cell Extender
- Subscriber Unit
- BreezeCONFIG( ACCESS
- Specifications
- Installing the Cell Extender
- Installing the SU-I Subscriber Unit
- Set-up and Initialization
- Aligning the Cell Extender’s SU-RA Antenna
- Aligning the SU-I Subscriber Unit’s Antenna
- Verifying Proper Operation
- Flexible Hopping Definition Mode
Chapter 2 - Installation
Wall Mounting the Unit
Use the supplied brackets for wall mounting to install the unit on a wall
or a ceiling.
To mount the unit on a wall:
1. Turn the unit so the rear panel is facing you.
2. Unscrew the two screws located at the antennas end of the unit (the
top screws).
3. Align the Unit Mounting Slots (see ) with the slots you
have just unscrewed.
Figure 2-9
Figure 2-9: Wall Mounting the SU-I
4. Using the longer screws supplied with the wall mounts, screw the
wall mount to the unit.
5. Align the Convenience Mounting Slots (see ) with the
nails, push the wall mount against the wall and let it slide down
until it rests on the nails.
Figure 2-10
Figure 2-10: Wall Mounting Plate
Special slots have been added to the wall mounts to allow for
unobtrusive cable installation. These slots should be used to fasten
cables coming out of the unit to the wall mounts, eliminating loose or
tangled cable installations.
Convenience Mounting Slots
Unit Mounting Slots
Cable Fastening Slots
BreezeACCESSS 900 System Manual
2-18