User's Manual
Table Of Contents
- System Description
- Introducing BreezeACCESS 900
- Cell Extender
- Subscriber Unit
- BreezeCONFIG( ACCESS
- Specifications
- Installing the Cell Extender
- Installing the SU-I Subscriber Unit
- Set-up and Initialization
- Aligning the Cell Extender’s SU-RA Antenna
- Aligning the SU-I Subscriber Unit’s Antenna
- Verifying Proper Operation
- Flexible Hopping Definition Mode
Installing the SU-I Subscriber Unit
Installing SU-I Units
Connectors and LEDs
The unit provides the following interfaces:
An Ethernet connector (marked ETH) on the rear panel for
connecting the unit to a PC.
A DC-IN 5V connector on the side panel for the power transformer.
A Monitor connector on the side panel for connecting an ASCII
terminal with terminal emulation software for configuration and
maintenance purposes.
An RF connector (marked 2) on the side panel for connecting to an
antenna.
The unit provides the following LED indicators on its front panel:
Table 2-3: Subscriber Unit’s LEDs
Name Description Functionality
POWER Power Supply On - After successful power up
Off - Power off
WLNK Wireless Link
Activity
Blinking - Receiving packets from the wireless link
Off - no reception of packets from the wireless link
ETHERNET Ethernet Activity Blinking - Reception of data from Ethernet LAN
Off - No reception of data from Ethernet LAN
Very low quality reception or not
synchronized with Access Unit
Low quality reception
(usually enabling 1Mbps traffic)
Medium quality reception
(usually enabling 2 Mbps traffic)
SIGNAL
QUALITY
Received Signal
Quality
High quality reception
(usually enabling 3 Mbps traffic)
Manual Revision 1.0 - Preliminary
2-17