User's Manual
Table Of Contents
- System Description
- Introducing BreezeACCESS 900
- Cell Extender
- Subscriber Unit
- BreezeCONFIG( ACCESS
- Specifications
- Installing the Cell Extender
- Installing the SU-I Subscriber Unit
- Set-up and Initialization
- Aligning the Cell Extender’s SU-RA Antenna
- Aligning the SU-I Subscriber Unit’s Antenna
- Verifying Proper Operation
- Flexible Hopping Definition Mode
Chapter 2 - Installation
To connect the IF cable:
1. Connect one end of the coaxial IF cable to the IF connector on the
bottom panel of the unit
2. Verify that the length of the IF cable is sufficient to reach the
Interface Unit.
3. The IF cable connectors should be sealed properly to protect against
rain and moisture
Figure 2-3: SU-RA-2.4 Bottom Panel
Installing the 900 MHz Antenna
Locate the 900 MHz antenna at least 20 cm (8 in.) away from the 2.4
GHz SU antenna or any other antenna. Refer to the installation
instructions included in the antenna kit for proper mounting guidelines.
Use only the antennas stated in of this manual. Table 2-2
NOTE
Verify that you use the correct polarization according to the results of the
spectrum analysis survey.
WARNING
ONLY experienced installation professionals who are familiar with local building
and safety codes and, wherever applicable, are licensed by the appropriate
government regulatory authorities should install outdoor units and antennas.
Failure to do so may void the BreezeACCESS product warranty and may expose
the end user or Service Provider to legal and financial liabilities. Alvarion and its
resellers or distributors are not liable for injury, damage or regulation violations
associated with the installation of Outdoor Units or antennas.
BreezeACCESSS 900 System Manual
2-8