User's Manual
Table Of Contents
- System Description
- Introducing BreezeACCESS 900
- Cell Extender
- Subscriber Unit
- BreezeCONFIG( ACCESS
- Specifications
- Installing the Cell Extender
- Installing the SU-I Subscriber Unit
- Set-up and Initialization
- Aligning the Cell Extender’s SU-RA Antenna
- Aligning the SU-I Subscriber Unit’s Antenna
- Verifying Proper Operation
- Flexible Hopping Definition Mode
Chapter 2 - Installation
Installing the SU-RA-2.4 Radio Unit
The following sections describe how to install the SU-RA Radio Unit,
including pole mounting the unit, and connecting the IF and grounding
cables.
Pole Mounting the SU-RA-2.4 Unit
The SU-RA Radio Unit can be mounted on a pole using one of the
following options:
Special brackets and open-ended bolts are supplied with each unit.
There are two pairs of threaded holes on the back of the unit,
enabling the special brackets to be mounted on diverse pole widths.
Special grooves on the sides of the unit enable the use of metal
bands to secure the unit to a pole. The bands must be 9/16 inches
wide and at least 12 inches long. The metal bands are not included
with the installation package.
Figure 2-1
Figure 2-1: Threaded Holes/Grooves
shows the locations of the holes and band grooves on the
back, top and bottom of the Outdoor Unit.
NOTE
Be sure to install the unit with the bottom panel, which includes the LED
indicators, facing downward.
BreezeACCESSS 900 System Manual
2-6