User's Manual
Table Of Contents
- System Description
- Introducing BreezeACCESS 900
- Cell Extender
- Subscriber Unit
- BreezeCONFIG( ACCESS
- Specifications
- Installing the Cell Extender
- Installing the SU-I Subscriber Unit
- Set-up and Initialization
- Aligning the Cell Extender’s SU-RA Antenna
- Aligning the SU-I Subscriber Unit’s Antenna
- Verifying Proper Operation
- Flexible Hopping Definition Mode
Installing the Cell Extender
For configuring basic parameters – a portable PC with Terminal
Emulation software (connected using the Dual Monitor cable)
OR
A portable PC with Ethernet NIC, a straight Ethernet cable and
Telnet software (or BreezeCONFIG ACCESS Configuration Utility)
Installation tools and materials, including appropriate means (e.g. a
pole) for installing the antennas.
Equipment Location Guidelines
This section provides key guidelines for selecting the optimal
installation locations for the various BreezeACCESS 900 system
components.
WARNING
ONLY experienced installation professionals who are familiar with local building
and safety codes and, wherever applicable, are licensed by the appropriate
government regulatory authorities should install outdoor units and antennas.
Failure to do so may void the BreezeACCESS product warranty and may expose
the end user or Service Provider to legal and financial liabilities. Alvarion and its
resellers or distributors are not liable for injury, damage or regulation violations
associated with the installation of Outdoor Units or antennas.
Select the optimal locations for the equipment using the following
guidelines:
Units should be installed in easily accessible locations to facilitate
installation and testing.
The higher the placement of the antennas, the better the achievable
link quality. (Locate the antennas at least 20 cm (8 in.) away from
each other or any other antenna.)
The antenna of the AU component of the Cell Extender should be
installed as close as possible to the Interface Unit to minimize loss
in the RF cable. The antenna should be installed so as to provide
coverage to all Subscriber Units within its service area.
NOTE
The Cell Extender equipment complies with the ETS 300 385 standard and is
protected against secondary lightning strikes when the Radio Unit and antenna
connected to it are properly grounded according to the relevant country specific
industry standards for protection of structures against lightning. The system
complies with EN 61000 4 5 test level 3 (2kV).
Manual Revision 1.0 - Preliminary
2-3