User's Manual

Chapter 2 - Installation
Installing the Cell Extender
Installation Requirements
This section describes all the supplies required to install the Cell
Extender and the items included in each installation package.
NOTE
Before proceeding beyond this point and installing the Cell Extender, the
spectrum survey should already be complete using the spectrum analysis tool
provided with this equipment (special firmware). The results of the survey will
identify the specific clear channels and polarization required to configure and
operate the 900 MHz equipment. Refer to the provided “Site Survey Procedure
and Spectrum Analysis Utility Manual” for detailed instructions on performing the
survey. This step is important to ensure the best performance from the product.
Packing List for CX-2.4-900 Cell Extender
The Cell Extender installation kit includes the following components:
 Interface Unit with a 15 ft. (4.5 m) open- ended power cable
 SU-RA-2.4 Radio Unit with an integrated 16 dBi antenna
 98 ft. (30 m) RG 58 IF cable with TNC connectors
 Sun guard for the Interface Unit
 RJ-45 Dual Monitor cable
 Outdoor type field-attachable Ethernet connector
 50 ft. (15 m) LMR-400 Antenna cable with N connectors
Additional Installation Requirements
The following items are also required to install the Cell Extender system
components:
 Grounding cables and other lightning protection materials according
to specific installation requirements
 ½ inch conduit for the power cable
 3 wire fused single phase 100 -240 VAC service (consult a licensed
electrician to install)
 Outdoor category 5 Ethernet cable (if a local Ethernet connection is
required)
BreezeACCESSS 900 System Manual
2-2