User's Manual
Table Of Contents
- System Description
- Introducing BreezeACCESS 900
- Cell Extender
- Subscriber Unit
- BreezeCONFIG( ACCESS
- Specifications
- Installing the Cell Extender
- Installing the SU-I Subscriber Unit
- Set-up and Initialization
- Aligning the Cell Extender’s SU-RA Antenna
- Aligning the SU-I Subscriber Unit’s Antenna
- Verifying Proper Operation
- Flexible Hopping Definition Mode
About this Guide
This manual describes the BreezeACCESS 900 Broadband Wireless
Access System Release 4.3 and how to install, initialize and operate the
system components.
This guide is intended for technicians responsible for installing, setting
up and operating the BreezeACCESS 900 system.
This guide contains the following chapters and appendices:
Chapter 1 – System description: Describes the BreezeAccess 900
system and its components.
Chapter 2 – Installation: Describes how to install the system
components.
Chapter 3 – Commissioning: Describes how to configure basic
parameters, align the antennas and validate unit operation.
Appendix A – Wiring 10Base-T jacks: Describes standard
10Base-T wiring schemes.
Appendix B –Mounting the Subscriber’s Antenna: Describes how
to install the Subscriber’s antenna.
Appendix C – Lightning and Grounding Kit Installation:
Describes how to install and connect the lightning protection and
grounding for the Subscriber’s antenna.
Appendix D – Configuring Hopping Frequencies and Operational
Sequences: Describes how to use the Flexible Hopping Definition
mode and the Hopping Shift parameter.