User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Verifying Proper Operation
4-5
BreezeACCESS 4.0 System Manual
SU-NI and AU-NI Indoor Units LEDs
BS-PS DC Power Supply Module
LEDs
BS-PS-AC AC Power Supply Module
LEDs
Name Description Functionality
PWR Power supply On – After successful power up, indicating that 12 VDC is
supplied to the outdoor unit.
Off – Power off or DC/DC converter failure (12 VDC not
supplied to the outdoor unit)
WLNK Wireless link
activity
Blinking – Receiving packets from the wireless media
Off – No reception of packets from the wireless media
Name Description
ON -48 VDC is available and Power Supply is ON
5V The 5V power supply module is OK and power is consumed (at least one
BS-AU module is inserted)
12V The 12V power supply module is OK and power is consumed (at least one
AU-RA/RE unit is connected)
Name Description
3.3V Green LED. Indicates that the 3.3 V power supply module is OK
(3.3V power supply is not used by current BreezeACCESS modules)
5V Green LED. Indicates that the 5 V power supply module is OK
12V Green LED. Indicates that the 12 V power supply module is OK
OVERTEMP Red LED. Indicates an Over Temperature condition in the power
supply module