User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
4-4
BreezeACCESS 4.0 Commissioning
Manual Revision: 1.01
LED Indicators
To verify correct operation of the units, view the status of the relevant
LED indicators:
SU-RA/RE Outdoor Units LEDs
AU-RE Outdoor Units LEDs
Name Description Functionality
ALARM Alarm
indication
On – A problem with the power amplifier or in the
locking process of any of the synthesizers
Off – Normal operation
WLNK Wireless link
activity
Blinking – Receiving packet from the wireless link
Off – No reception of packets from the wireless link
ETH Ethernet
activity
Blinking – Data received from or transmitted to Ethernet
LAN
Off – No activity on the Ethernet LAN
Name Description Functionality
ALARM Alarm
indication
On – A problem with the power amplifier or in the
locking process of any of the synthesizers
Off –Normal operation
12V IN 12 VDC
Power
Indication
On – 12 VDC power is supplied to the unit
Off – 12 VDC power is not available
ETH Ethernet
activity
Blinking – Data received from or transmitted to
Ethernet LAN
Off – No activity on the Ethernet LAN