User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Verifying Proper Operation
4-3
BreezeACCESS 4.0 System Manual
Verifying Proper Operation of the
GU-RA GPS Antenna
When the unit is operating properly, the PWR and OK green LEDS
should be on, indicating that the unit is supplying power to the GPS
antenna and that the GPS antenna is functioning properly.
If the OK LED is not on, check the functionality of the GPS antenna as
follows:
1. From the Main Menu, select Info Screens.
The Info Screens menu opens.
2. From the Info Screen menu, select Show Unit Status and view the
Unit Status display. You should see one of the following messages:
UTC is available; date..; time..: This message indicates that
the GPS antenna has synchronized with the satellite system and that
the BS-GU is functioning properly. The message may include an
incorrect time and date, such as a date in 1999: this indicates that
the GPS antenna has not yet synchronized with the GPS satellite
system.
–Or–
UTC time is not available
: This message indicates that the
BS-GU is not getting timing signals from the GPS antenna. If the
antenna is functioning and properly connected to the module, a
probable reason might be that the antenna has not yet synchronized
with the GPS satellite system.
NOTE:
It may take up to 10 minutes from the time the GU-RA GPS antenna is powered up until
it is fully synchronized with the GPS satellite system.