User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Setting Basic Parameters
1-11
BreezeACCESS 4.0 System Manual
Configuring Hopping Parameters
1. From the Basic Configuration menu, select Hopping Parameters.
The Hopping Parameters menu opens.
2. From the Hopping Parameters menu, select Number of Hopping
Frequencies.
The Number of Hopping Frequencies configuration screen appears.
Enter the number of hopping frequencies used by the system.
3. From the Hopping Parameters menu, select Synchronization Signal
Source.
The Synchronization Signal Source configuration screen appears.
Select the required option: GPS Antenna or Internal or Local (from
other GU).
Configuring VLAN Parameters
1. From the Advanced Configuration menu, select Bridge Parameters.
The Bridge Parameters menu appears.
2. From the Bridge Parameters menu, select VLAN Support.
The VLAN Support menu appears.
3. From the VLAN Support menu, select VLAN ID – Management.
The VLAN ID – Management configuration screen appears. Select the
required VLAN ID value (enter 65535 for no VLAN).
Resetting the Unit
After completing the process of configuring the basic parameters, the
unit should be reset so that all new settings are applied.
1. From the Main Menu, select Unit Control.
The Unit Control menu opens.
2. From the Unit Control menu, select Reset Unit.
The Reset Unit configuration screen opens. Type 1 to reset the unit
so that new configuration settings are applied.
NOTE:
You may determine the number of hopping frequencies being used by the system by
viewing Number of Hopping Frequencies in the Show Basic Configuration screen of
any configured AU.