User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
1-10
BreezeACCESS 4.0 Commissioning
Manual Revision: 1.01
Configuring Parameters in
GU-A-BS Units
Introduction
This section describes all the parameters that are necessary for the
initial installation and operation of GU-RA units. Once the unit is
properly installed and operational, other parameters can be configured
using the monitor program via Telnet or SNMP management.
Since all the parameters needed are found in the Advanced
Configuration menu, Admistrator level access is required in order to
configure a GU-RA unit.
Refer to Book 4: Operation and Administration for detailed information
on the applicable parameters.
Configuring IP Parameters
1. From the Advanced Configuration menu, select DHCP Client.
The DHCP Client menu appears.
2. From the DHCP Client menu, select DHCP Options
The DHCP Options menu opens. Choose the required option:
Disable, DHCP Only or Automatic.
If DHCP Only is selected, proceed to the next parameter.
If Disable or Automatic is selected, continue to step 3.
3. From the Basic Configuration menu, select IP Address.
The IP Address configuration screen appears. Enter the required IP
address.
4. From the Basic Configuration menu, select Subnet Mask.
The Subnet Mask configuration screen appears. Enter the required
subnet mask.
5. From the Basic Configuration menu, select Default Gateway
Address.
The Default Gateway Address configuration screen appears. Enter
the required default gateway address.
NOTE:
The GU-RA does not have an external MON port, and therefore must be configured
using Telnet.