User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Setting Basic Parameters
1-9
BreezeACCESS 4.0 System Manual
! Define at least one of the four WEP Keys by selecting one of
them from the Security Parameters menu and entering the
required key.
! Select Default Key ID from the Security Parameters menu and
enter the number of a defined WEP key.
! Select Authentication Algorithm from the Security Parameters
menu.
The Authentication Algorithm menu opens.
Select Shared Key.
Resetting the Unit
After completing the process of configuring the basic parameters, the
unit should be reset so that all new settings are applied.
1. From the Main Menu, select Unit Control.
The Unit Control menu opens.
2. From the Unit Control menu, select Reset Unit.
The Reset Unit configuration screen opens. Type 1 to reset the unit
so that new configuration settings are applied.
NOTE:
The Shared Key option cannot be selected until at least one WEP Key and the
appropriate Default Key ID are configured.