User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
1-8
BreezeACCESS 4.0 Commissioning
Manual Revision: 1.01
! Select Hopping Shift from the Basic Configuration menu.
The Hopping Shift configuration screen appears. Select the
required hopping shift value.
Configuring VLAN Parameters
1. From the Basic Configuration menu, select VLAN Support.
The VLAN Support menu appears.
2. From the VLAN Support menu, select VLAN Link Type.
The VLAN Link Type configuration screen appears. Select the
required option: Hybrid, Access or Trunk Link.
3. From the VLAN Support menu, select VLAN ID – Management (VLAN
ID – Voice and Management in subscriber units with voice support).
The VLAN ID – Management (or VLAN ID – Voice and Management)
configuration screen appears. Select the required VLAN ID value
(enter 65535 for no VLAN).
Configuring Best AU Parameters
(SU Only)
1. From the Basic Configuration menu select Best AU Parameters.
The Best AU Parameters menu opens.
2. From the Best AU Parameters menu, select Best AU Support. Select
the required option, Enable or Disable.
Configuring Preferred AU Mac
Address (SU Only)
! If Best AU Support is enabled, you may elect to set the
Preferred AU MAC Address parameter by selecting Preferred
AU MAC Address from the Best AU Parameters menu and
entering the MAC address of the preferred AU.
Configuring Security Parameters
1. From the Basic Configuration menu, select Security Parameters.
The Security Parameters menu opens
2. If the required authentication algorithm is Open System, select
Authentication Algorithm from the Security Parameters menu.
The Authentication Algorithm menu opens.
Select Open System.
3. If the required algorithm is Shared Key, do the following: