User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Setting Basic Parameters
1-5
BreezeACCESS 4.0 System Manual
Configuring Basic Parameters
in Access and Subscriber
Units
Introduction
The Basic Configuration menu includes all the parameters that are
necessary for the initial installation and operation of BreezeACCESS
units. Once the unit is properly installed and operational, other
parameters can be configured using the monitor program or via either
the Ethernet port or the wireless link using Telnet or SNMP
management.
Refer to Book 4: Operations and Administration for detailed information
on the applicable parameters.
Configuring IP Parameters
1. From the Basic Configuration menu, select the DHCP Client menu
2. From the DHCP Client menu, select the DHCP Options menu and
choose the required option: Disable, DHCP Only or Automatic.
! If you have selected Disable, configure the following parameters:
" From the Basic Configuration menu, select IP Address.
The IP Address configuration screen appears. Enter the
required IP address.
" From the Basic Configuration menu, select Subnet Mask.
The Subnet Mask configuration screen appears. Enter the
required subnet mask.
" From the Basic Configuration menu, select Default Gateway
Address.
The Default Gateway Address configuration screen appears.
Enter the required default gateway address.
! If you have selected DHCP Only, select Access to DHCP. The
Access to DHCP menu opens. Select the required access option:
From Ethernet Port Only, From Wireless Port Only or From
Both Ethernet and Wireless Ports.
! If you have selected Automatic, configure the following
parameters: