User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Commissioning
Table of Contents
Setting
Basic Parameters ....................................................1-1
Accessing the Monitor Program ..............................................1-2
Accessing the Monitor Program using the
RS 232 MON Connector ....................................................1-2
Accessing the Monitor Program using Telnet .....................1-4
Operating the Monitor Program ..........................................1-4
Configuring Basic Parameters in
Access and Subscriber Units ...................................................1-5
Introduction .........................................................................1-5
Configuring IP Parameters .................................................1-5
Configuring ESSID Parameters ..........................................1-6
Configuring Frequency Hopping Parameters ....................1-7
Configuring VLAN Parameters ...........................................1-8
Configuring Best AU Parameters (SU Only) ......................1-8
Configuring Preferred AU Mac Address (SU Only) ............1-8
Configuring Security Parameters .......................................1-8
Resetting the Unit ...............................................................1-9
Configuring Parameters in GU-A-BS Units ...........................1-10
Introduction .......................................................................1-10
Configuring IP Parameters ...............................................1-10
Configuring Hopping Parameters .....................................1-11
Configuring VLAN Parameters .........................................1-11
Resetting the Unit .............................................................1-11
Optimizing
the Wireless Link .....................................................2-1
RSSI Measurement and Maximum Data Rate Configuration
(Subscriber Units) ......................................................................2-2
Aligning the Antenna of the SU-A/E Subscriber Unit .............2-3
Connecting
External Alarm
Devices ....................................................................3-1
Connecting External Devices to the
GU-BS AL IN and/or AL OUT Connectors ...............................3-2