User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
IF Based Equipment
1-21
BreezeACCESS 4.0 System Manual
Table 1-10: BS-GU Connectors
Connector Name Functionality
SYNC IN Receives signals from the GPS antenna unit.
If more than one collocated BS-GU module uses a single GPS
antenna, this connector is used by a “Slave” unit to receive
synchronization signals from the “Master” unit.
SYNC OUT Sends synchronization signals to “Slave” BS-GU modules.
AL IN Four connections to receive indications from external devices.
AL OUT Three relay outputs to external devices.
ETH Ethernet 10BaseT interface. Use a straight cable to connect
directly to a PC. Use a crossed cable to connect to a hub.
Table 1-11: Front Panel LEDs and Switches
LED Name Functionality
PWR (green) On – Power supply functioning properly.
Off – Power supply not functioning properly.
OK (green) On – Proper signals are being received from the GPS antenna.
Off – The GPS antenna is not connected or it is not functioning
properly.
A1 (red) On – Alarm In 1 (external) is activated.
A2 (red) On – Alarm In 2 (external) is activated.
A3 (red) On – Alarm In 3 (external) is activated.
A4 (red) On – Alarm In 4 (external) is activated.
A5, A6 (red) Reserved for future use.
Ethernet Activity -
Ethernet Connector
embedded LED (green)
On – Receiving traffic on the Ethernet port.
Off – No activity on the Ethernet port.
Ethernet Integrity -
Ethernet Connector
Embedded LED
(orange)
On – Unit is connected to an Ethernet segment.
Off – Unit is not connected to an Ethernet segment.
Reset Press this button with a paper clip or similar object in order to
reset the unit.