User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
1-16
BreezeACCESS 4.0 Installation
Manual Revision: 1.01
Figure 1-9: BS-PS-AC Front Panel
The BS-PS-AC provides a power input connector (marked AC IN) for
connecting the AC power cable to the mains.
The ON/OFF power switch controls the connection of the mains power
to an AC to DC converter.
Table 1-8: BS-PS-AC LEDs Functionality
Name Description
3.3V Green LED. Indicates that the 3.3V power supply module is OK (3.3V
power supply is not used by current BreezeACCESS modules)
5V Green LED. Indicates that the 5V power supply module is OK
12V Green LED. Indicates that the 12V power supply module is OK
OVER TEMP Red LED. Indicates an Over Temperature condition in the power supply
module
NOTE:
If the Over Temp indication stays on for more than 10 seconds, the power supply
module will shut itself offautomatically to prevent damage.