User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Chapter 1
IF-Based
Equipment
This chapter describes the basic installation of BreezeACCESS IF-based
equipment, including SU-A/E subscriber units, modular base station
equipment and stand-alone AU-E-NI access units. It includes the
following sections:
! Packing Lists‚ page 1-2, lists the equipment that is packed with
each BreezeACCESS IF-based unit.
! Guidelines for Selection of Equipment Locations‚ page 1-5, gives
tips and guidence for locating BreezeACCESS equipment for
optimum performance.
! Installing the Outdoor Unit‚ page 1-7, explains how to install the
outdoor elements of BreezeACCESS systems.
! Installing the SU-NI and AU-NI Indoor Unit‚ page 1-12, outlines
the installation procedures for SU-NI and AU-NI units.
! Installing Modular Base Station Equipment‚ page 1-14, outlines
the installation procedures for modular base station equipment.
! Installing the GU-A-BS GPS and Alarms System‚ page 1-20,
outlines the installation procedures for a GPS and Alarms system.
About This Chapter