User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
2-10
BreezeACCESS 4.0 System Description
Manual Revision: 1.01
BreezeCONFIG
The BreezeCONFIG ACCESS configuration utility can also be used to
manage BreezeACCESS system components. It is an SNMP-based
application that provides a consistent view of the network and
the system administrator can use it to control a large number of units
from a single location.
BreezeCONFIG has the following system requirements:
! Windows 95/98/NT/2000/ME/XP
! 128 MB RAM recommended, 64 MB Minimum
Some of the features BreezeCONFIG supports are:
! Verifying units’ status and current configuration
! Changing the configuration of a selected unit
! Simultaneously changing the configuration of multiple units
! Viewing traffic statistics and performance data
! Monitoring traps
! Performing firmware upgrade to a single or multiple units
NOTES:
The BreezeCONFIG utility can be downloaded from the Alvarion Web site:
www.alvarion.com
.
The currently released version of BreezeCONFIG (SW version 4.0.50) does not support
BreezeACCESS V units.