User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Appendix D
D-3
BreezeACCESS 4.0 System Manual
Air Interface Parameters
Parameter Unit Range Default Run-Time
Updated
ESSID AU, SU Up to 31 printable ASCII
characters
ESSID1 No
Operator ESSID
Option
AU Disable, Enable Enable No
Operator ESSID AU Up to 31 printable ASCII
characters
ESSID1 No
Hopping Sequence AU Depends on hopping standard 1 No
Hopping Set AU 1-3 1 No
Hopping Sync AU Idle, Master, Slave Idle No
Best AU Support SU Disable, Enable Disable No
Number of Scanning
Attempts
SU 1 – 255 20 Yes
Preferred AU MAC
Address
SU MAC Address 00-00-00-00-00-
00 (no preferred
AU)
Yes
Transmit Power
Control
AU-A/E,
SU-A/E (IF
based units)
0 – 15 15 Yes
Power Level SU-R, SU-I/
AU-I
Low, High High No
Transmit Antenna SU-R
SU-I/AU-I
Use Two Antennas,
Use Antenna No. 1,
Use Antenna No. 2
Use Antenna
Number 1
No
Receive Attenuation
Control
SU-A/E (IF
based units)
0, 10dB, 25dB 0 No
Maximum Data
Rate
AU, SU 1, 2 and 3Mbps 3Mbps No
Acknowledge Delay
Limit
AU, SU Low, Medium, High Low No
Maximum Number
of Associations
AU 1 – 512 512 Yes
Call Aging Time AU 1 (no aging), 2-50,000 (seconds) 1800 seconds No
Maximum Voice
Sessions
AU 0 – 50 12 Yes
ACSE Option AU and GU Disable, Enable Disable No
ACSE Maximum
Voice Sessions
AU 0 – 21 21 Yes