User's Manual

B-40
BreezeACCESS 4.0 System Manual
Manual Revision: 1.01
Traps
Trap (Number) Description Variables
*SUassociatedAUTRAP(2) An AU trap indicating a new
association with an SU.
*TrapSUMacAddr
*AUdisassociatedTRAP(3) An AU trap indicating that an SU has
been disassociated from the AU. The
AU decides that an SU has been
disassociated from it and remove it
from the ADB after receiving from
another AU a SNAP frame with the SU
MAC address. The SNAP frame
indicating a network topology change
where the SU has associated with
another AU will be received if both
AUs are connected to the same
Ethernet backbone.
*TrapSUMacAddr
*AUagingTRAP (4) An AU trap indicating that an SU was
aged out and removed from the ADB
following its failure to acknowledge a
certain number of consecutive frames
transmitted to it.
*TrapSUMacAddr
*SUassociatedTRAP (6) An SU trap indicating association with
an AU. In addition to the MAC address
information of the AU, the trap also
includes information on the average
RSSI of frames received from the AU.
*AssociatedAU
*LastAUMacAddress
*TrapRssiQuality
*TrapLastRssiQuality
*SUWirelessQualityTRAP(7) An SU trap, indicating that the quality
of the wireless link has changed and
dropped below (On) or has improved
above (Off), defined by the
*WirelessTrapThreshold.
The threshold is in RSSI units.
*TrapToggle
*UnitMacAddress
*TrapRssiQuality
*AUWirelessQualityTRAP(20) An AU trap, indicating that the quality
of the wireless link with a specific SU
has changed and dropped below (On)
or has improved above (Off) a
threshold defined by
*WirelessTrapThreshold. The
threshold is a percents
(retransmissions as percentage of
total transmissions).
*TrapToggle
*TrapRTx
*PowerUpFromReset (101) A trap indicating power up after Reset. *UnitMacAddr
*MonitorStatusTRAP (102) A trap indicating that a log-in or
log-out has been performed via the
Monitor port or Telnet. Includes the
log-in access right and the IP address
of the PC performing Telnet (if access
is via Monitor the address is 0)
*TrapLog
*TrapAccessRights
*TrapTelnetUserIpAddress
*ParameterChangedTRAP(103) An AU or SU trap indicating a change
in a CIR/MIR, IP Filter, Accounting or
VLAN parameter.
*TrapParameterChanged
*GpsAlarmInTRAP (104) A GU trap indicating a change in
alarm-in status
*brzaccTrapToggle
*AlarmName
*AlarmNumber
*GpsAlarmOutTRAP (105) A GU trap indicating a change in
alarm-out status
*brzaccTrapToggle
*AlarmName
*AlarmNumber
*GpsUTCstatusTRAP (106) A GU trap indicating a change in UTC
status. On status is when the GU
module receives UTC information
from the GPS antenna. This
information is useful only if the GU
receives also PPS signals from the
GPS antenna, indicated by an on
status of Alarm In 5 (GPS Antenna
Alarm).
*TrapToggle