User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
B-22
BreezeACCESS 4.0 System Manual
Manual Revision: 1.01
Site Survey Parameters
MIB Parameter
(Location in Parenthesis)
Description Values/Range
*SiteSurvey
710.3.3. 8
(brzAccessMib 8)
PerHopStatisticsTable
710.3.3. 8.1
(*SiteSurvey 1)
Applicable to SU and AU. Statistics
accumulated since last reset and average RSSI
per frequency for all hopping frequencies in the
(sequence). Not Accessible.
hopSeqEntry
710.3.3. 8.1.1
(perHopStatisticsTable 1)
Applicable to SU and AU. A Per Hop Statistics
Table entry. Not accessible.
wPperHopStatisticsTable
710.3.3. 8.1.1.1
(hopSeqEntry 1)
Applicable to SU and AU. Read-only. The
channel number according to the hopping
sequence.
Integer
hopTracerRx
710.3.3. 8.1.1.2
(hopSeqEntry 2)
Applicable to SU and AU. Read-only. The
accumulated number of frames received since
last reset at the applicable frequency.
Integer
hopTracerTx
710.3.3. 8.1.1.3
(hopSeqEntry 3)
Applicable to SU and AU. Read-only. The
accumulated number of frames transmitted since
last reset at the applicable frequency.
Integer
hopTracerRetries
710.3.3. 8.1.1.4
(hopSeqEntry 4)
Applicable to SU and AU. Read-only. The
accumulated number of frames retransmitted
since last reset at the applicable frequency.
Integer
hopTracerRSSI
710.3.3. 8.1.1.5
(hopSeqEntry 5)
Applicable to SU and AU. Read-only. The
average RSSI of frames received at the
applicable frequency.
DisplayString (SIZE(20))
* hopTracerFreq
710.3.3. 8.1.1.6
(hopSeqEntry 6)
Applicable to SU and AU. Read-only. The
frequency in MHz of the entry.
DisplayString (SIZE(9))
*TrafficStatistics
710.3.3. 8.2
(*SiteSurvey 2)
Applicable to SU and AU. Traffic Statistics
parameters.
*ResetTrafficCounters
710.3.3. 8.2.1
(*TrafficStatistics 1)
Applicable to SU and AU. Resets the Ethernet
Counters (*EthCounters) and the Wireless Link
Counters (*WlanCounters).
Integer
noReset (0)
reset (1)
*EthCounters
710.3.3. 8.2.2
(*TrafficStatistics 2)
Applicable to SU and AU. Ethernet counters.
*TotalRxFramesViaEthernet
710.3.3. 8.2.2.1
(*EthCounters 1)
Applicable to SU and AU. Read-only. Total
number of frames received via the Ethernet port.
Counter
*TxWirelessToEthernet
710.3.3. 8.2.2.2
(*EthCounters 2)
Applicable to SU and AU. Read-only. Total
number of frames transmitted to the Ethernet
port.
Counter
*WlanCounters
710.3.3. 8.2.3
(*TrafficStatistics 3)
Applicable to SU and AU. Wireless link counters.
*TotalTxFramesToWireless
710.3.3. 8.2.3.1
(*WlanCounters 1)
Applicable to SU and AU. Read-only. The
number of frames transmitted to the wireless
media. The count includes one count for each
data or RTP frame that was transmitted
successfully (excluding retransmissions), and
also the number of transmitted control and
management frames.
Counter