User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Appendix B
B-21
BreezeACCESS 4.0 System Manual
*SyncSignalSource
710.3.3. 7.12.1
(*GpsHoppingParams 2)
Applicable to GU Only. The source of the
synchronization signal.
When using a single GU, it should
always be configured to 1
(gPSAntennaOrInternal).
When using several daisy-chained units
and a GPS Antenna is connected to the
first unit, than all units should be
configured to 1 (gPSAntennaOrInternal).
When using several daisy-chained units
without a GPS antenna, than the first
unit that generates the self-
synchronization signals for all other units
should be configured to 1
(gPS_AntennaOrInternal). All other units
that receive the synchronization signals
from the first unit should be configured to
2 (localFromOtherGU ).
Integer
gpsAntennaOrInternal (1)
localFromOtherGU (2)
na (255)