User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
B-12
BreezeACCESS 4.0 System Manual
Manual Revision: 1.01
*HoppingSync
710.3.3. 6.7
(*AirInterface 7)
Applicable to BS-AU only.
Inter-AU hopping sync functionality
of the unit.
In the BreezeACCESS II family,
synchronization among AUs is not
available with the following Country
Standards: US FCC, Australia,
Canada.
In the BreezeACCESS V family,
synchronization is not available if
the selected hopping band is
ISM US FCC.
Integer
idle (0)
slave (1)
master (2)
na (255)
*HoppingShift
710.3.3. 6.8
(*AirInterface 8)
Applicable to AU in
BreezeACCESS V, XL and MMDS
families and in BreezeACCESS II if
*HoppingBands is
frqFlexibleHopping.
Defines a hopping pattern different
from the basic hopping sequence
(Hopping Shift=0). Different
collocated AUs should use different
hopping shifts.
Integer
na (255)
Range 0 to [number of operational
channels-1]