User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
B-8
BreezeACCESS 4.0 System Manual
Manual Revision: 1.01
Bridge Parameters
MIB Parameter
(Location in Parenthesis)
Description Values/Range
*BridgeParameters
710.3.3. 5
(brzAccessMib.5)
Bridge parameters.
*EthBroadcastFiltering
710.3.3. 5.1
(*BridgeParameters 1)
Applicable to SU only.
Enables/disables the filtering of Ethernet
(layer2) broadcasts.
disable: No filtering.
ethOnly: Filter broadcasts received on the
Ethernet port only.
wlanOnly: Filter broadcasts received on the
Wlan port only.
bothWlanAndEth: Filter broadcasts received
on both ports.
Integer
disable (0)
ethOnly (1)
wlanOnly (2)
bothWlanAndEth(3)
na (255)
*VLANSupport
710.3.3. 5.2
(*BridgeParameters
2)
Applicable to AU, SU and GU. VLAN Support
Parameters.
*VlanID
710.3.3. 5.2.1
(*VLANSupport 1)
Applicable to SU only. VLAN ID for data frame
tagging. Applicable to Access Link only.
Integer
1-4094.
0 means not applicable
*EthernetLinkType
710.3.3. 5.2.2
(*VLANSupport 2)
Applicable to AU and SU. VLAN support
mode (Link Type).
The Access Link option is not available for AU.
Integer
accessLink (1)
trunkLink (2)
hybridLink (3)
*ManagementVID
710.3.3. 5.2.5
(*VLANSupport 5)
Applicable to AU, SU and GU. VLAN ID for
management frame tagging. For SUs with
voice support it is also used for tagging voice
frames (RTP packets).
Integer
1-4094
65535 means no VLAN
tagging.
*VoicePriorityTag
710.3.3. 5.2.6
(*VLANSupport 6)
Applicable to SU with voice only. Enables
prioritization tagging of voice (RTP) frames
according to IEEE 802.1p when
*ManagementVID is 65535 (No VLAN).
Integer
disable (0)
enable (1)
na (255)
*VLANForwarding
710.3.3. 5.2.7
(*VLANSupport 7)
VLAN Forwarding Feature Parameters
*VlanForwardingSupport
710.3.3. 5.2.7.1
(*VLANForwarding 1)
Applicable to AU and SU. Enables or disables
VLAN Forwarding. (applicable in Trunk links
only)
Integer
disable (0)
enable (1)
na (255)
*VlanForwardingTable
710.3.3. 5.2.7.2
(*VLANForwarding 2)
Applicable to AU and SU. A VLAN Forwarding
Table of up to 20 VLAN IDs of devices to
which data frames are forwarded when VLAN
Forwarding is Enabled. (applicable in Trunk
links only). Not accessible.
*VlanForwardingEntry
710.3.3. 5.2.7.2.1
(*VlanForwardingTable 1)
Applicable to AU and SU. A VLAN Forwarding
Table entry. (applicable in Trunk links only).
Not accessible.
*VlanForwardingIdx
710.3.3. 5.2.7.2.1.1
(*VlanForwardingEntry 1)
Applicable to AU and SU. A read only table
index for a VLAN entry in the VLAN
Forwarding Table.
Integer
0 - 19
*VlanIdForwarding
710.3.3. 5.2.7.2.1.2
(*VlanForwardingEntry 2)
Applicable to AU and SU. The list of VLAN
ID's in the VLAN ID Forwarding Table. To
Remove a VLAN ID - SET the corresponding
entry to 0. To Add a new VLAN ID SET an
entry which is currently 0.
Integer
1-4094
0=remove entry.
*VLANRelaying
710.3.3. 5.2.8
(*VLANSupport 8)
VLAN Relaying Feature Parameters