User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Menus and Parameters
2-81
BreezeACCESS 4.0 System Manual
" Alarm In 7: PS1 Over Temperature (over temperature
indication for BS-PS Power Supply module 1, which is the
module inserted in the left-most slot of the chassis).
" Alarm In 8: PS2 Over Temperature (over temperature
indication for BS-PS Power Supply module 2, which is the
module inserted in the right-most slot of the chassis).
" Alarm In 9: PS1 Power (power fail indication for BS-PS Power
Supply module 1, which is the module inserted in the left-
most slot of the chassis).
" Alarm In 10: PS2 Power (power fail indication for BS-PS
Power Supply module 2, which is the module inserted in the
right-most slot of the chassis).
! Alarms Out Names, Definitions, Control and Status
Displays the following information for each of the three Alarms Out:
" Name: Name according to the name defined in the Alarms In
Names Menu.
" Definition: NONE, Alarm In # or ANY, according to the
configuration in the Automatic Alarms Out Definition Menu.
" Control: OFF, ON or AUTO, according to the configuration in
the Alarms Out Control Menu.
" Status: ON or OFF.
NOTE:
In some installations only one Power Supply module (either PS1 or PS2) may
be used.