User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
2-58
BreezeACCESS 4.0 Operations and Administration
Manual Revision: 1.01
the value of this parameter will increase the probability that
it will be a successful window, thus slowing down the
decision to degrade to a lower rate and accelerating the
decision to upgrade to a higher rate.
Valid value: 1 to Multi-Rate Decision Window Size.
Default value: 8.
! Dwell Time (AU only) – The time spent on a radio channel before
hopping to the next channel according to the operational hopping
sequence.
The allowed selections are 32, 64 and 128 Kilo-microseconds.
The default value is 128 Kilo-microseconds.
When the ACSE Option is enabled this parameter is not applicable
and the dwell time is the ACSE Dwell Time, set to a fixed value of 60
milliseconds.
Service Parameters (AU and SU)
The Service Parameters menu includes the following parameters:
! User Filtering Parameters – Only available in SUs. Defines IP
addresses of user’s devices that are authorized to access the
wireless media, serving for security and/or control purposes. It can
also be used to enable transmission/reception of specific protocol
frames only. These filtering functions do not affect management
frames that are sent to or generated by the unit or.
Choose this option to define the following parameters:
" User Filtering Option – Disables or enables the User
Filtering feature. The available options are:
# Disable (No filtering).
# IP Only (only IP Protocol packets pass).
# User Defined Addresses Only (only messages from IP
addresses included in the User Filter Addresses list pass).
# PPPoE Protocol Only (only PPPoE frames pass - Ethernet
type 0x8863 and 0x8864).
The default selection is Disable.
" Set User Filter Address – Displays the current User Filter IP
addresses. Allows you to enter up to 8 IP addresses to be
used if the User Defined Addresses Only option was selected
in the User Filtering Option above.
The default for all addresses is 000.000.000.000.
" Set User Filter Mask – Displays the current masks. Allows
you to enter subnet masks for each of the User Filter IP
Address entries.