User's Manual

Menus and Parameters
2-43
BreezeACCESS 4.0 System Manual
" Send SNMP Traps – Enables/disables sending of SNMP
traps. Available options are:
# Enable Traps Sending
# Disable Traps Sending
The default selection is Disable Traps Sending.
" SNMP Traps IP Destination – Displays the current values of
3 IP addresses that are defined as the trap destinations.
Allows entering a new address (4 groups of 3 digits each,
separated by dots) for each of the 3 entries.
The default of all three SNMP Traps IP Destinations is
000.000.000.000.
" SNMP Traps Community – Defines a new community string
for each of the 3 SNMP Trap IP Destination entries.
Valid strings: Up to 14 ASCII characters, case sensitive.
The default for all 3 entries is public (read-only).
" Show SNMP Traps Parameters – Displays the current
values of the SNMP Traps parameters.
! Show Network Management Parameters – Displays the current
values of the Network Management parameters.
Bridge Parameters (AU, SU and GU)
The Bridge Parameters sub-menu includes the following parameters
sets:
! Virtual LAN (VLAN) parameters
! ToS parameters
! Ethernet Broadcast Filtering parameters
! Other Bridging parameters
VLAN Parameters
! VLAN Support – Defines the parameters that are related to the
VLAN-aware (Virtual LAN-aware) feature of BreezeACCESS units.
Each VLAN includes stations that can communicate with each
other, but cannot communicate with stations belonging to different
VLANs. The VLAN also provides the ability to set traffic priorities for
transmission of certain frames. The information related to the VLAN
is included in the VLAN Tag Header, which is inserted in each frame
between the MAC header and the data. VLAN implementation in
BreezeACCESS units supports frames routing by port information
(i.e. each port is connected to only one VLAN).
The VLAN Support option allows viewing and setting of the
following parameters: