User's Manual

2-42
BreezeACCESS 4.0 Operations and Administration
Manual Revision: 1.01
" Disable – No IP address based filtering
" Activate Management IP Filter On Ethernet Port –
Applicable only if the Access to Network Management
parameter is configured to either From Ethernet Only or
From Both Ethernet & Wireless Link. The unit can be
managed from the Ethernet port only by stations whose IP
addresses match one of the entries in the Set Network
Management IP Addresses list. If the Access to Network
Management parameter is configured to From Both
Ethernet & Wireless Link, than there is no IP address
based filtering on the wireless port.
" Activate Management IP Filter On Wlan Port – Applicable
only if the Access to Network Management parameter is
configured to either From Wireless Link Only or From Both
Ethernet & Wireless Link. The unit can be managed from
the wireless link port only by stations whose IP addresses
match one of the entries in the Set Network Management IP
Addresses list. If the Access to Network Management
parameter is configured to From Both Ethernet & Wireless
Link, then there is no IP-address-based filtering on the
Ethernet port.
" Activate Management IP Filter On Both Ethernet & Wlan
Ports – Applicable with all options of the Access to Network
Management parameter. The unit can be managed from the
port(s) defined by the selected option of the Access to
Network Management parameter only by stations whose IP
addresses match one of the entries in the Set Network
Management IP Addresses list.
The default selection is Disable.
! Set Network Management IP Addresses – Displays the IP
addresses of the stations that can manage the unit (if Network
Management Filtering option was enabled) and allows you to enter
new addresses; up to three IP addresses can be defined.
The default value is 000.000.000.000 for all 3 addresses.
! Delete a Network Management IP Address – Deletes one of the 3
IP address entries from the list of Network Management IP
Addresses.
! Delete All Network Management IP Addresses – Deletes all entries
from the list of Network Management IP Addresses.
! SNMP Traps – Enables/disables transmission of SNMP traps; if this
option is enabled, you can define up to 3 IP addresses of stations to
which SNMP traps are sent.
NOTE:
In the GU only the Disable and Enable Management IP Filtering on Ethernet
Port options are available.