User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Menus and Parameters
2-41
BreezeACCESS 4.0 System Manual
Valid values are from 0 (no retransmissions) to 100.
The default value is 6.
" ACSE Number Of Retransmissions For Voice (AU and SU
with voice support) – The maximum number of times that a
voice packet that was not acknowledged will be
retransmitted. When the ACSE Option is enabled, this
parameter overrides the Number Of Retransmissions
parameter. This parameter has no effect when the ACSE
Option is disabled.
Valid values are from 0 (no retransmissions) to 100.
The default value is 30.
" Show ACSE Parameters – Displays the current settings of
all ACSE parameters. The display in the SU includes the
ACSE Option, which is only configurable in the AU. It also
includes the ACSE Dwell Time, which is set to 60
milliseconds.
Network Management Parameters
(AU, SU and GU)
This feature allows protecting the unit from trials of unauthorized
access by defining a set of IP addresses from which management of the
unit (Telnet, TFTP, SNMP, ICMP) is allowed (excluding transmission of
messages generated in the unit such as Traps or Ping Test frames). This
feature also supports the possibility of defining the direction (from the
wireless media or from the wired Ethernet or from both) from which
such access is allowed. The Network Management Parameters menu
includes the following options:
! Access to Network Management – Defines the port through which
the unit can be managed. The options are the following:
" From Wlan Only
" From Ethernet Only
" From Both Ethernet & Wlan
The default selection is From Both Ethernet & Wlan.
! Network Management Filtering – Enables/disables management
filtering. If management filtering is enabled, the unit can only be
managed by stations whose IP addresses match one of the entries in
the Set Network Management IP Addresses (see next parameter)
that are connected to the unit via the defined port(s). Available
options are:
NOTE:
The Access to Network Management option is not available in the GU, as this module
does not have a wireless link interface.