User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
2-22
BreezeACCESS 4.0 Operations and Administration
Manual Revision: 1.01
! DHCP Client
" DHCP Options – Displays the current status of the DHCP
(Dynamic Host Configuration Protocol) support, and allows
selecting a new operation mode. The available options are:
# Disable – Use manual procedure for configuring the IP
parameters.
# DHCP Only – Search for a DHCP Server and obtain the IP
parameters from it (IP Address, Subnet Mask and
Default Gateway Address).
# Automatic – Search for a DHCP Server for configuration
of the IP parameters. If a DHCP Server is not found within
approximately 40 seconds, use the currently configured IP
parameters.
The default is Disable.
" Access to DHCP – To define the port through which the unit
is allowed to communicate with a DHCP server. The options
are:
# From Wlan Only
# From Ethernet Only
# From Both Ethernet & Wlan
The default for an Access Unit is From Ethernet Only. The
default for a Subscriber Unit is From Wlan Only.
! Show IP Parameters – Displays the current values of the IP
Parameters.
Air Interface Parameters (AU and
SU)
Hopping Frequencies Setting Parameters
The process of setting the hopping sequence includes the following
steps:
a. Select the frequencies to be used
b. Define the method of generating the basic hopping sequence based on
the set of selected frequencies. The method of generating the basic
sequence also defines the hopping shift mechanism for generating
different actual hopping sequences.
NOTE:
The Access to DHCP option is not available in the GU, as this module does
not have a wireless link interface.