User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Menus and Parameters
2-21
BreezeACCESS 4.0 System Manual
Advanced Configuration Menu
The Advanced Configuration menu provides access to all the
parameters, including the parameters that are available through the
Basic Configuration menu.
The Advanced Configuration menu provides access to the following
menus:
! IP Parameters (AU, SU and GU) (see page 2-21)
! Air Interface Parameters (AU and SU) (see page 2-22)
! Network Management Parameters (AU, SU and GU) (see page 2-41)
! Bridge Parameters (AU and SU) (see page 2-43)
! VLAN Parameters (GU) (see page 2-43)
! Performance Parameters (AU and SU) (see page 2-55)
! Service Parameters (AU and SU) (see page 2-58)
! Security Parameters (AU and SU) (see page 2-62)
! Voice Parameters (SU with voice support) (see page 2-63)
! Dialing Parameters (SU with voice support) (see page 2-64)
! Telephony Signals Parameters (SU with voice support)
(see page 2-71)
! Hopping Parameters (GU) (see page 2-77)
! Alarm Parameters (GU) (see page 2-78)
IP Parameters (AU, SU and GU)
The IP Parameters sub-menu allows configuration of the following
parameters:
! IP Address – Displays the current IP address of the unit and allows
the entry of a new IP address (four sets of three digits, separated by
dots).
The default IP Address is 010.000.000.001.
! Subnet Mask – Displays the current subnet mask of the unit and
allows entry of a new subnet mask (four sets of three digits,
separated by dots).
The default mask is 255.000.000.000.
! Default Gateway Address – Displays the current address of the
default gateway of the unit and allows entry of a new default
gateway address (four sets of three digits, separated by dots).
The default is 000.000.000.000.