User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
2-6
BreezeACCESS 4.0 Operations and Administration
Manual Revision: 1.01
Unit Control Menu
The Unit Control menu includes the following options:
! Reset Unit – Resets the BreezeACCESS unit and applies any
changes made to the system parameters.
! Defaults Settings – Resets the unit to a predefined set of default
parameters or to save the current configuration as Operator
Defaults. The available options are:
" Set Defaults – Resets the unit to a set of default parameters.
The following options are available:
# Cancel Request – Exits to the Unit Control menu without
any change.
# Set Complete Factory Defaults – Available only with
Administrator access rights. Resets the unit to the set of
Alvarion’s standard default values. These are the default
values as defined in this manual for each of the
parameters. After the next Reset Unit command (see
above) all parameters will revert to their Factory Defaults
value, except for the Passwords.
# Set Partial Factory Defaults – Resets all parameters to
the values of the Factory Defaults configuration, except
for parameters that are necessary to maintain
connectivity and to enable management. These are the
parameters included in the Basic Configuration menu,
except to the Maximum Data Rate parameter. In addition,
Passwords and VLAN parameters are not changed.
# Set Complete Operator Defaults – Available only with
Administrator access rights. Set the unit to its’ Operator
Defaults configuration. After the next Reset Unit
command (see above) all parameters will revert to their
Operator Defaults values, except for the Passwords.
Operator Defaults configuration can be defined by the
Administrator (see Save Current Configuration As
Operator Defaults below). It may also be defined at the
factory according to customer’s definition. The default
Operators Defaults configuration is the Factory Defaults
configuration.
The complete Operator Defaults Configuration file can be
downloaded/uploaded using TFTP with the SNMP Write
NOTE:
Activating Set Complete Factory Defaults will result in loss of connectivity.
If the unit is managed remotely, you may lose the ability to communicate
with it.