User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Menus and Parameters
2-5
BreezeACCESS 4.0 System Manual
antenna. If the antenna is functioning and properly
connected to the module, this may be because the antenna
has not yet synchronized with the GPS satellite system.
Show Basic Parameters
The Show Basic Parameters menu displays the current values of the
parameters included in the Basic Configuration menu (see Basic
Configuration Menu‚ page 2-10). When using Read-Only access rights
the ESSID and WEP Keys are not displayed. The display includes some
additional useful read-only information such as the Number of
Hopping Frequencies in SU and AU.
Show Advanced Parameters
The Show Advanced Parameters menu enables access sub-menus that
display the current values of the parameters included in the applicable
sub-menus of the Advanced Configuration menu (see Advanced
Configuration Menu‚ page 2-21). When using Read-Only access rights
the ESSID (Air Interface Parameters) and WEP Keys (Security
Parameters) are not displayed. The display includes some additional
read-only information such as Number of Hopping Frequencies (Air
Interface Parameters).
Show All Parameters
The Show All Parameters menu displays the current values of all the
parameters included in the Advanced Configuration menu. When using
Read-Only access rights, ESSID and WEP Keys are not displayed. The
display includes some additional useful read-only information such as
the Number of Hopping Frequencies (SU and AU).