User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
2-4
BreezeACCESS 4.0 Operations and Administration
Manual Revision: 1.01
! Console Speed – Displays the speed defined in the unit for the
connected terminal, used for running the terminal emulation
program.
! Number of Associations Since Last Reset – In SUs displays the
total number of associations with any AU since the last reset,
including duplicate associations with the same AU. In AUs, displays
the number of SUs that have associated with the AU since the last
reset, including duplicate associations with the same SU.
The following parameters appear for Subscriber Units only:
! Voice Hardware Version (SU with voice support only) – Displays
the hardware version of the voice module.
! Unit Status – Displays the current status of the SU. There are two
possible values:
" SCANNING – The SU is searching for an AU with which to
associate.
" ASSOCIATED – The SU is associated with an AU.
! AU MAC Address – Displays the MAC address of the AU with which
the unit is currently associated. If the unit is not associated with
any AU, the address will be that of the IEEE broadcast address:
FF-FF-FF-FF-FF-FF.
The following parameter appears for Access Units only:
! Current Number of Associations – Displays the total number of
SUs associated with this AU. This number may include units that
are not currently active, as there is no aging algorithm for
associated SUs.
The following parameter appears for GPS Modules only:
! Unit Status – Indicates the status of the GPS antenna. Either one of
the following messages may be displayed:
" UTC is available; date..; time..: This message
indicates that the GPS antenna has synchronized with the
satellite system and that the BS-GU is functioning properly.
The message may include an incorrect time and date, such
as a date in 1999. This indicates that the GPS antenna has
not yet synchronized with the GPS satellites system.
–Or–
" UTC time is not available: This message indicates that
the BS-GU is not getting timing signals from the GPS
NOTE:
An SU will be removed from the list of associated SUs only upon occurrence of any of
the following: (1) The AU received from another AU a SNAP frame with the SU MAC
address indicating that the SU has become associated with the other AU, or (2) The AU
has decided that the SU aged out following its failure to acknowledge a certain number
of consecutive frames transmitted to it.