User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
Menus and Parameters
2-3
BreezeACCESS 4.0 System Manual
Info Screens Menu
Figure 2-1: Info Screens Menu
The Info Screens menu enables viewing of the current values of various
parameter sets. The parameter sets are identical to the main parameter
groups in the configuration menus. The user can view a specific
parameter set or can elect to view all parameters (S). This menu is
available for all access levels.
Show Unit Status
The Show Unit Status menu displays the current values of the following
parameters:
! Unit Type – Identifies the unit’s function as one of the following:
Access Unit, Subscriber Unit or GPS and Alarms Module.
! Unit MAC Address – Displays the unit’s unique IEEE MAC address.
! Unit Hardware Version – Displays the hardware version of the unit
(the indoor module of IF based products).
! Flash Type – Displays the type and size of the Flash memory.
! Flash Versions
" Current Version – Displays the software version that is
currently active.
" Shadow Version – Displays the software version currently
defined as the shadow (backup) version.
" Version After Reset – Displays the software version that will
be used after the next reset.
BreezeACCESS/AU-BS
Official Release Version – 4.0.40
Release Date: Thu Dec 20 21:05:08 2001
Info Screens
====================
1 – Show Unit Status
2 – Show Basic Parameters
3 – Show Advanced Parameters
S – Show All Parameters
>>>