User's Manual

Appendix B. Basic Parameters
BreezeACCESS Series 39 Base Station Equipment Installation Manual
∗ An updated list of all the hopping frequencies to be used after the
next Reset.
∗ The current sequence of operational hopping frequencies
•
Hopping Sync
(BS-AU only) – Displays the current Hopping Sync status
of the unit and allows defining a new status. When several AUs that use the
same frequencies and different Hopping Shifts are co-located, their
operation should be synchronized in terms of Hopping Shift initialization
and timing. One unit must be specified as a Master Unit and all other units
must be specified as Slave units. Available options are:
⇒ Idle – No synchronization (stand-alone operation)
⇒ Master – The AU that serves as a Master unit providing
synchronization signals to the Slave units
⇒ Slave – An AU that operates as a Slave
The default is Idle.
Parameters Specific for BreezeACCESS XL
The following parameters are only relevant to BreezeACCESS XL products.
Note:
The Hopping band and Hopping Offset parameters are applicable for
applications that use a 2MHz channel spacing. For other channel spacing
values, or for hopping bands/frequency configurations that are not
supported by the standard Hopping Band values, use Flexible Hopping
Definition as described on page 41.
•
Hopping Band
– Displays the current bandwidth and allows entry of a new
bandwidth. The bandwidth is determined based on the specific conditions of
the license to use a given frequency band, and on other considerations. The
available selections are 10, 12, 14, 24, 28, 36, 42 and 50 MHz (some
selections are not available in models with a total available bandwidth lower
than 50 MHz). In addition, a Single Channel selection is also available.