User's Manual

Appendix B. Basic Parameters
Base Station Equipment Installation Manual 38 BreezeACCESS Series
⇒
Add Frequencies
– Allows adding discrete hopping frequencies or
frequency ranges. Enter a list of frequencies and/or frequency ranges
to be added, e.g. 2501.500,2407.500-2519.500, 2525.500.Use a
comma to separate between entries (no spaces). The allowed entries
are from 2500 to 2688 in steps of 0.5MHz. The frequencies (either the
start and stop frequencies of a range or discrete frequencies) can be in
the following formats:
MHz Resolution, e.g. 2520
kHz resolution, e.g. 2501.000,2505.500 (you must enter 3 digits after
the dot).
The minimal channel spacing between frequencies is 3MHz. When
entering a range, this will be the default channel spacing (e.g. for the
range 2510-2516 the hopping frequencies will be 2510, 2513 and 2516
MHz).
It is recommended to use the standard MMDS frequencies. See
Appendix C for a list of the standard MMDS frequencies.
⇒
Remove Frequencies
- Allows removing frequencies from the
existing list. Enter a list of frequencies and/or frequency ranges to be
removed, using the same guidelines as in Add Frequencies above
⇒
Add Channels
– Allows defining a new list of channels or adding
channels to an existing list. Enter a list of channels to be added, e.g.
A1,B3,D2. Use a comma to separate between entries (no spaces). See
Appendix C for a list of the channels and the hopping frequencies for
each of the channels.
⇒
Remove Channels
– Allows removing channels from existing list.
Enter a list of channels to be removed, using the same guidelines as in
Add Channels above.
⇒
Erase All
– Allows erasing all the entries from the list.
⇒
Show Flexible Hopping Parameters
– Allows viewing the following
information:
∗ An updated list of the defined sub-bands and discrete frequencies
to become effective after the next Reset. A sub-band is defined by
the first and last hopping frequency in a series of consecutive
frequencies, with 3MHz separation between frequencies.