User's Manual

Appendix B. Basic Parameters
Base Station Equipment Installation Manual 34 BreezeACCESS Series
∗
Automatic
– Search for a DHCP Server for configuration of
the IP parameters. If a DHCP Server is not found within
approximately 40 seconds, use the currently configured IP
parameters.
The default is Disable.
⇒
Access to DHCP -
To define the port through which the unit is
allowed to communicate with a DHCP server. The options are the
following:
∗ From Wlan Only
∗ From Ethernet Only
∗ From Both Ethernet & Wlan
The default for an Access Unit is From Ethernet Only. The
default for a Subscriber Unit is From Wlan Only.
Parameters Specific for BreezeACCESS II
The following parameters are set in BreezeACCESS II products.
•
Hopping Sequence
– Displays the Hopping Sequence of the unit.
A hopping sequence is a pre-defined series of channels (frequencies) that are
used in a specific, pseudo-random order as defined in the sequence. The unit
“hops” from frequency to frequency according to the selected sequence.
When more than one AU is co-located in the same area, it is recommended to
assign different hopping sequences to each AU.
Hopping Sequences are grouped in three hopping sets (see Hopping Set
parameter below). When setting up multiple AUs in the same site, always
choose hopping sequences from the same Hopping Set to reduce the
possibility of collisions on the wireless media. This parameter is only set in
the AU. All the SUs learn it from the AU during the association process.
The permitted range depends on the applicable hopping standard (see Table
5-1 on the next page). The default value is 1.