User's Manual

Appendix A. Using Telnet
BreezeACCESS Series 31 Base Station Equipment Installation Manual
APPENDIX A. USING TELNET
Use the following procedure to connect to BreezeACCESS units via a Telnet
session.
1. Connect the PC to the Ethernet port of the unit (or the hub to which the unit is
connected) using a straight Ethernet cable. If you connect the PC directly to a
unit that is normally connected to a hub, use a crossed Ethernet cable. You
may also connect the PC to any Ethernet port on the network and
communicate with the unit to be managed via the wired or wireless media.
2. Make sure that the PC’s IP parameters (IP address and subnet mask) are
configured to enable connectivity with the unit.
3. Start the Telnet application by selecting
, Run and then typing Telnet
in the Run dialog box.
4. Select Connect-Remote System from the Telnet window menu. The following
dialog box is displayed.